How to properly manage the setting of a device?
The aim of proper setting of a device is to achieve energy balance and collect as much data as possible at the same time. There are 2 ways to approach this aim:
- BOOST (Intelligent Dynamic Setting)
BOOST can automatically adjust working frequency based on battery level and movement speed to achieve maximum utilization of battery. Click here to know more.
The default setting of BOOST (start and stop voltage threshold, speed threshold, working interval, etc.) is based on large amount of data and experience in the past, which is also adjustable. Please contact us for more information.
Unless you think a device is not able to charge properly for a period, it is suggested that you keep BOOST on for the device.
- User Programmed Setting
When BOOST is on, you can also change the device setting with pre-set mode or customized mode. Below are suggestions on different charging conditions.- A battery curve (can be generated on Analysis page on data center) that fluctuates at a high level means good charging condition. In this case you can set the working frequency higher in a proper manner.
- A battery curve that fluctuates at a normal level means normal charging condition. In this case you can keep the current working frequency as it is.
- A battery curve that keeps dropping, or rises and drops but drops on a whole, means bad charging condition. In this case you can set the working frequency lower in a proper manner.
If you choose on-time transmission, it is suggested to set the time between 1~4 p.m. as in the time zone where the bird is located. Transmission failure because of low battery may occur less as battery level is higher during this period than at other times.